Installation Guide

A
B
C
D
ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# 1031 1032 1033
For Wall Mount Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Disconnect power at main electrical panel before
installation.
2. Thread the two mounting screws about 1/4” into the
pre-drilled holes in the mounting plate, spaced about
the same distance apart as the holes in the fixture back
plate. Attach the mounting plate to the junction box
using two junction box screws. The side of the
mounting plate marked “GND” must face out.
3. Guide fixture wires through hole in center of mounting
plate.
4. Follow wiring instructions carefully (see fig.2)
5. Place the fixture body (C) over the mounting plate，
aligning the hole with mounting screw, then screw the
ball nuts (D) onto the mounting screws.
6. Attach the glass shade (B) onto the lamp holder, then
lock it securely with check ring (A).
7. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You may wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE