Personal ECG Device User Manual
User Manual Contents 1. Introduction ........................................................ 1 2. Warnings ............................................................ 1 3. Packing List........................................................ 4 4. Guide to Parts ................................................... 5 5. Using the Device ............................................... 7 5.1. Charge and activate your device ........... 7 5.2. Download Livenpace App........................ 8 5.3.
1. Introduction It is intended to record and store electrocardiogram (ECG) rhythms, and transfer records to compatible mobile App for further research or analysis. It is not a medical device and should not be used for any medical purposes or any medical conditions. It is intended only for general wellness use. 2. Warnings The ECG results (including regular heartbeat) do not guarantee that you are free from an arrhythmia or other health conditions.
medical decision, such as altering your use of any drug or treatment. Do not continue to use the device until further instructed by a physician if your skin is irritated or inflamed around the electrodes. The device makes no warranty for any erroneously collected data or information from misuse or malfunction as a result of abuse, accidents, alteration, negligence, or failure to maintain the products as instructed.
Do not take a recording while driving or during physical activity. Do not store in extremely hot, cold, humid, wet, or bright conditions. Do not take a recording if the electrodes are dirty. Clean them first. Do not immerse the device in or expose the device to excessive liquid. Do not drop or bump with excessive force. Do not expose to strong electromagnetic fields. Do not expose the device to a magnetic resonance (MR) environment.
Do not place the electrodes in contact with other conductive parts including the earth. Do not use with unapproved accessories. The use of unapproved accessories or transducers and cables may result in electromagnetic emissions or decreased electromagnetic immunity of this device and result in improper operation. Do not use the device adjacent to or stacked with other equipment because it may result in improper operation. 3.
4.
Flashing with the rhythm of the heartbeat Green light Recording your ECG On Fully charged Flashing every 5 seconds In standby mode Recording your ECG Charging In standby mode Low Battery Flashing with the rhythm of the heartbeat Orange light On Flashing every 5 seconds Connected to the App and ready to start recording Connected to the App and recording your ECG On Blue light Flashing with the rhythm of the heartbeat 6
5. Using the Device 5.1 Charge and activate your device a) Put the device on the charging base. Note: Do not put in backwards. Ensure proper contact between the device and the base. b) Connect the charging base with power adapter by the USB cable. Note: The power adapter is not included in the package. Compatible power adapter output: DC 5V, 1A Do not use the device while charging.
5.2 Download Livenpace App a) Download the Livenpace App from iOS App Store or Google Play Store. Or you can scan the QR code below. Note: Be sure to use a compatible iOS or Android device. iOS: iOS 10.0 or above Android: Android 7.0 or above b) Make sure Bluetooth is turned on in Settings of your smartphone or tablet.
c) Launch the Livenpace App and follow the instructions in the App to set up and pair your device. Note: For more information on how to use the software, visit the website https://livenpace.com/pages/support or scan the QR code below. 5.
Lead I Hold onto the device with both hands. Note: If the ECG quality is poor with Lead I, please try to use Lead II. Lead II Hold the right electrodes with the right hand, place the left electrodes on the left leg.
Chest lead with chest strap Attach the device to the chest strap. Position the monitor across the front of the chest as shown, and ensure the electrodes are in contact with the skin. Adjust the strap so that it wraps around tightly yet comfortably.
Note: Please make sure that the “R” symbol is always on the right hand or chest. Do not use the electrodes on a portion of the body with too much body fat, body hair or very dry skin; otherwise, a successful recording may not be possible. b) Hold still for at least 30 seconds. Note: You can turn on/off the heartbeat sound of the device in the App.
Result Description Regular No rhythm abnormalities heartbeat were detected in your ECG. Irregular Some rhythm abnormalities heartbeat were detected in your ECG. There is too much Poor signal interference in this recording. Your heart rate is less than Slow heart 50 beats per minute, which rate is slower than normal for most people. Your heart rate exceeds 120 Fast heart beats per minute. This can rate be normal with stress or physical activity.
Note: All historical results can be viewed, downloaded, and shared in the App. 6. Maintenance No service or repair should be performed on the hardware other than the maintenance listed in this section. It is important to keep the electrodes clean by spraying with an alcohol-based sanitizer and wiping with a soft cloth when needed.
7. Troubleshooting If you experience difficulties in operating your device, refer to the troubleshooting guide below. Problem: Solution My device is Option: Charge the device. not working. Problem: Solution Poor signal. Option 1: Ensure that your arms, hands and left leg remain still. Option 2: Clean the electrodes with an alcoholbased sanitizer. Option 3: If your hands are very dry, use a water-based lotion before recording.
Problem: Solution The ECG Option: Ensure that the right rhythms hand or chest contacts the appear right electrode. upside down. 8.
Power and supply Rechargeable lithium-polymer battery Capacity: 90mAh Rating: DC 5V, 5W ECG and HR Heart rate range: 30 to 250 BPM ECG Measuring length: 30 seconds to 15 minutes Others Dimension: 92×32×8.2 mm (main unit) Weight: 26.8g (main unit) Wireless connectivity: Bluetooth® 5.
9. Symbols Symbol Description Indicates a medical device that is not to be disposed of as unsorted municipal waste. IP22 Resistant to liquid ingress This product complies with the rules and regulations of the Federal Communication Commission.
10. FCC Statement FCC Warning: FCC ID: 2A728-0002 Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna.
Shenzhen Livenpace Technology Co., Ltd. 402, Floor 4, BLD 9, Baiwangxin High-Tech Industrial Park, Songbai Road, Nanshan District, 518110, Shenzhen, Guangdong, P.R.
