Operation Manual

12 GB/IE
power (eco mode). When fully charged, the
batteries will provide approx. 8 hours of light in this
setting.
Position „PIR“: The solar cell charges the batteries in sunlight. The
solar cell
6
automatically switches the spotlight on
in twilight or the dark when the motion sensor
3
detects movement. The light ON time is preset to ap-
prox. 1.5 minutes. If additional movement is detected
during these 1.5 minutes, the light ON time will reset.
In this setting the LEDs will be fully powered. With the
batteries fully charged the charge on this setting will
provide light for a total of approx. 2 hours.
Maintenance / changing batteries
To ensure good solar cell
6
performance the solar cell must be cleaned
regularly (see „Cleaning and care“).
Change the batteries as follows:
Slide the switch
5
to the „OFF“ position.
Loosen the cover screws
11
the back of the main unit
1
using a
cross-tip screwdriver (see Fig. E).
Remove the back of the main unit.
Remove the batteries from the battery compartment
10
and replace
with new rechargeable batteries with the same technical data. Be sure
to insert the batteries in the correct direction. The correct polarity is
shown inside the battery compartment.
Close the back of the main unit and secure the cover screws.