Operation Manual

11 GB/IE
Then attach the solar cell as shown in Fig. C.
Next adjust the solar cell to face south.
Connecting the solar cell to the main unit
After mounting the two operating units (main unit
1
and solar cell
6
) run
the cable so it is not subjected to mechanical stress. Use typical installation
material such as cable clamps or conduit to fasten the cable, to prevent
damage to the insulation.
Connect the plug connector
4
from the main unit cable and the solar
cell (see Fig. D).
Start-up
Note:
Connect the main station
1
to the solar cell
6
before using for the
first time. The solar cell
6
also works as a twilight sensor, while the
motion sensor
3
only responds to movement.
When selecting the setup location for the solar cell
6
be sure the
solar cell, just as the twilight sensor, are not affected by other light
sources, e.g. street lighting.
The switch
5
on the main unit
1
(Fig. A) features the following functions:
Position „OFF“: Sensor
3
and spotlight
2
are off. In direct sunlight
the rechargeable batteries are charged by the solar
cell
6
. Use this setting to charge drained batteries
(see „Charging the rechargeable
batteries“).
Position „AUTO“: The spotlight automatically switches on or off once
the solar cell
6
detects dusk or dawn. To ensure a
long life the LEDs will not be fully powered in this set-
ting, but only provide approx. 25 % of their full light