Operation Manual
19 GB/IE
Note: The light-on time is approx. 1 hour,
assuming the battery is charged in colar cell for
about 6 hours.
Sensor
During periods of twilight or darkness, the sen-
sor
7
registers a change in the angle of heat
radiation, triggered by people passing by the
sensor (Fig. I). When the sensor recognises a
moving person the light is switched on. The light
goes off after approx. 40 seconds, after the last
movement was recognised.
Installation
When selecting the mounting location, pay
attention to the following:
1.
The solar cell
6
requires direct sunlight wh
en
possible. Ideally, the solar cell surface will be
directed to the south. The horizontal direction
of the solar cell is dependent on mounting
on a vertical wall.
2. Depending on the mounting height (ideally
at 2 m) the sensor
7
has a detection range
of max. 5m with a detection angle of 100°
horizontally and 90° vertically.
3. Be sure the sensor is not illuminated by street
lighting at night. This can influence the effect.
Fix the mounting plate
2
using the provided
rawlplugs
1
(ø 6 mm) and the provided
screws
3
. Ensure that the arrow on the
marking of the mounting plate (
UP) is show-
ing vertically upward (Fig. A).
Note: The enclosed mounting material is
suitable for ordinary masonry construction.
Other wall substrates may require other fas-
tening materials. Seek specialist advice when
in doubt.
Set the ON / OFF switch
11
to the position
„ON“ to start the operation of the product
(Fig. G).
Note: In the „OFF“ position both the light
and the charging function are disabled.
Attach the product to the mounting plate in
such a way that the hangers
4
of the
mounting plate grip in the receivers
5
on