08.2020 - 1.633.
TURN ON & TURN OFF TAG CHARGE Please press the blue button for 2 seconds to turn on the device. The LED will turn on and the device will vibrate. Use a standard qi 10 W wireless charger. Put the device on the charger with Litum logo facing up towards you. Please press the blue button for 2 seconds to turn on the device. The LED will turn off and the device will vibrate. Red LED will remain on until charge is complete and it will turn off when the charge is complete or the device is off the charger.
TAG CARE When the device is on, the LED will blink every 5 seconds displaying also the battery level. Battery level indicators: Red: Critical Orange: Low Green: Good Your tag comes with IP 65 which is dust and water splash protected from any direction. Please do not submerge the tag in water. Please refrain from leaving or charging your tag in direct sunlight or drop it on hard surfaces. Make sure to check your tag LEDs occasionaly to ensure it functions properly. www.litumiot.com | support@litum.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
