Operating Instructions

4
INSTALL SCREWS
Firmly install all screws until they are pulled flush
against the plastic surface of the anchor. All screws
must be firmly installed to prevent unwanted
movement of the anchor. Ensure the device is
securely fastened to the wall.
Disassemble connector as shown below. Connect
the power cable and then reassemble the
connector to complete. All components must be
fastened properly to ensure water resistency.
5A
POWER CABLE
CONNECTION
HOW TO MOUNT
1
Print the anchor/gateway drilling template.
Use it with bubble level and place it on the wall.
LOCATE & MARK
2
DRILL &
INSERT WALL PLUGS
Drill the four holes on the template
and insert wall plugs.
3