User Manual

WARNING
• This product contains small magnets. Swallowed magnets can
stick together across intestines causing serious infections
and death. Seek immediate medical attention if magnets are
swallowed or inhaled.
• Most littleBits are small parts. DO NOT allow children under
3 years old to play with or near this product.
• NEVER connect any littleBits or circuits to any AC
electrical outlet.
• Do not touch or hold any moving parts of littleBits while
they are operating.
• Keep conductive materials (such as aluminum foil, staples,
paper clips, etc.) away from the circuit and the connector
terminals.
• Always turn off circuits when not in use or when left
unattended.
• Never use littleBits in or near any liquid.
• Never use in any extreme environments such as extreme hot or
cold, high humidity, dust or sand.
• littleBits are subject to damage by static electricity.
Handle with care.
• Some littleBits may become warm to the touch when used in
certain circuit designs. This is normal. Rearrange modules or
discontinue using if they become excessively hot.
• Discontinue use of any littleBits that malfunction, become
damaged or broken.
VERY IMPORTANT NOTE
• Several projects in this kit involve the use of a box
cutter, grill skewers and/or a hot glue gun.
• These tools should be used ONLY under direct adult
supervision and ONLY by children capable of using them safely.
INSTRUCTIONS
We recommend using littleBits brand 9-volt batteries, but
standard alkaline or standard rechargeable batteries may also
be used. Properly discard and replace exhausted battery.
Do not connect the two battery terminals with any conducting
material.
CARE AND CLEANING
Clean Bits modules ONLY by wiping with a dry cloth. If
necessary, isopropyl alcohol on a cloth may be used sparingly,
and then wipe with a dry cloth.
DO NOT use any other cleaning products on Bits modules.
Congratulations for reading this fine print. Your dedication
and persistence will serve you well.
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Changes and Modifications not expressly approved by the
manufacturer or registrant of this equipment can void
your authority to operate this equipment under Federal
Communications Commissions rules.
SEND US YOUR LOVE
Contact [e-mail] with any questions
or comments.
www.littleBits.cc
littleBits Electronics Inc.
60 E. 11th Street
NY, NY 10003
[phone]
You are a proud owner of the Premium Kit v1 from the
Exploration Series. Over 600,000 combinations?! Are you
serious? Yep, www.littleBits.cc/mathmagic
An open source project under Creative Commons license
and OSHW definition v1.1
littleBits Electronics, Inc.
Made in Dongguan City, China
littleBits, Bits, Circuits in Seconds, and Make Something That
Does Something are trademarks of littleBits Electronics, Inc.