User Manual

3
2.1.0 Delivery of Items to littleBits
2.1.1 If your bitLab submission is approved, a GitHub repository
will be created for your module and initialized with LB
preferred folder structure.
2.1.2 Replace the templates and placeholders in the repository
with your deliverables, and commit and push your changes
to GitHub.
2.2.0 Examples
2.2.1 littleBits provides a full example project including all of the
deliverables listed above in the rtmTemplate repository,
which will be shared upon acceptance of your bitLab
module.
3.0.0 Design Requirements
3.0.1 System Parameters:
VCC = 5VDC
BitSnap connector max current = 1A
Nominal temperature range = 10C to 40C
3.0.2 Female bitSnap connector pinout:
Pin 1: GND (ground, 0VDC)
Pin 2: SIG (signal, 0 to 5 V continuous)
Pin 3: VCC (power, 5VDC)
3.0.3 Male bitSnap connector pinout:
Pin 1: VCC (power, 5VDC)