User Manual

15
components. Smash parts as needed. Names should
generally be placed along the long side of the component
(lengthwise) and the value along the short side
(widthwise). This can be reversed if the length of the text
is inversely proportional and the values are longer than
the names.
7.2.0 Routing
7.2.1 The traces which are already routed in the templates may
be altered if necessary.
7.2.2 Minimum track width is 0.008 inches (0.2032mm). Default
track width is 0.016 inches (0.4064mm).
7.2.3 Minimum clearance requirement is 0.008 inches
(0.2032mm).
7.2.4 Traces should run at 90 and 45˚ angles with routes
running parallel. Avoid other angles and arcs.
7.2.5 Vias must be round, and have a 0.4064mm drill diameter.
Avoid placing vias directly on the silkscreen text on the
top side of the board.
7.2.6 There should be a Ground Pour on both layers unless a
VCC plane is needed.
Polygon settings:
Width = 0.008inches (0.2032mm)