Instructions

PRESS DOWN ON
BITSNAPS NOT
WHITE CIRCUIT
BOARD.
Use the included #6 screws in any
of the holes to permanently attach
to any surface.
a26 MOUNTING BOARD
MEET THE ACCESSORY
HOW IT WORKS
The mounting board is like
the backbone of some of
your inventions. It allows
you to keep your circuit
intact and move it around
with ease! It also provides
structure, which is helpful
for building out inventions
like a vehicle.
Snap together your littleBits
circuit and press the feet of
your Bits into the holes of the
mounting board.
NOTE: Your circuit must be
complete before you press
it onto the board. You won't
be able to add Bits one at
a time.
connect to servo hub
with included #6
screws, optional
MEET THE ACCESSORY
a24 SERVO MOUNT
The servo mount lets you
attach your servo to a
mounting board or a pair of
littleBits shoes. With feet on
two sides of the mount, you
can orient the servo in all
directions. It’s a great way to
keep the servo steady so the
arm can go wild.
HOW IT WORKS
To use the servo mount:
Carefully separate the white
plug from the circuit board.
Slip the plug through the
vertical slot in the servo
mount. Pull the wire through
until the servo sits on top
of the servo mount. Press
the servo into the mount.
Reconnect the white plug to
the board.
For extra security, screw the
servo to the mount using the
included #6 screws.
feet for mounting
boards and shoes
USE A PHILLIPS-HEAD
SCREWDRIVER
wire opening