User manual

ZyAIR G-4100
6
Table 2 Front Panel LEDs
LED STATUS DESCRIPTION
ZyAIR On (Blue) The ZyAIR is ready, but is not sending/receiving data through the wireless
LAN.
Blinking (Blue) The ZyAIR is sending/receiving data through the wireless LAN.
LAN (1-4) On (Green) The port is connected to a 10/100Mbps Ethernet device.
Blinking (Green) The port is receiving or sending data.
Off The port is not connected to a 10/100Mbps Ethernet device.
WAN On (Green) The WAN port has a connection to your cable or DSL modem.
Blinking (Green) The WAN port is sending or receiving packets.
Off The WAN link is not ready, or has failed.
SYS On (Green) The ZyAIR is ready and running.
Off The ZyAIR is not ready or has failed.
PWR On (Green) The ZyAIR is receiving power.
Off The ZyAIR is not receiving power.
1.4 Factory Defaults
Table 3 Factory Defaults
Username “admin” (case sensitive) WAN IP Address DHCP Client (dynamic WAN IP)
Password “1234” LAN IP Address 192.168.1.1
LAN DHCP Server
2 Setting Up Your Computer’s IP Address
Skip this section if your computer is already set up to accept a dynamic IP
address. This is the default for most new computers.
The ZyAIR is already set up to assign your computer an IP address. Use this section to set up your
computer to receive an IP address or assign it a static IP address in the 192.168.1.2 to 192.168.1.254