Installation & Assembly

Lay base on its side. Position
lower post on its side (as shown).
Thread hose through hole located
at the bottom of the lower post and
out through the other end.
AGES 3+ YEARS
ADULT SUPERVISION REQUIRED
SKU: 648496C
18 7
The Little Tikes Company makes fun, high quality toys. We warrant o the original purchaser that this product is free of defects in materials or workmanship for
one year * from the date of purchase (dated sales receipt is required for proof of purchase). At the sole election of The Little Tikes Company, the only remedies
available under this warranty will be the replacement of the defective part or replacement of the product. This warranty is valid only if the product has been
assembled and maintained per the instructions. This warranty does not cover abuse, accident, cosmetic issues such as fading or scratches from normal wear, or
any other cause not arising from defects in material and workmanship. *The warranty period is three (3) months for daycare or commercial purchasers.
U.S.A and Canada: For warranty service or replacement part information, please visit our website at www.littletikes.com, call 1-800-321-0183 or write to:
Consumer Service, The Little Tikes Company, 2180 Barlow Road, Hudson OH 44236, U.S.A. Some replacement parts may be available for purchase after warranty
expires—contact us for details.
Outside U.S.A and Canada: Contact place of purchase for warranty service. This warranty gives you specic legal rights, and you may also have other rights, which
vary from country/state to country/state. Some countries/states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
LIMITED WARRANTY
Please keep this manual as it contains important information.
MGA Entertainment (Netherlands) B.V.
Klipperaak 201, 2411 ND Bodergraven, NL
Tel: [phone]
E-mail: [e-mail]
© The Little Tikes Company, an MGA Entertainment company.
LITTLE TIKES® is a trademark of Little Tikes in the U.S. and other
countries. All logos, names, characters, likenesses, images, slogans,
and packaging appearance are the property of Little Tikes.
MGA Entertainment UK Ltd
50 Presley Way
Crownhill
Milton Keynes
MK8 0ES
Bucks, UK
0800 521 558
Visit our website at
www.littletikes.com
to register your product and
to enter our sweepstakes.
(No purchase necessary)
Printed in China
1018-0-C
Little Tikes Consumer Service
2180 Barlow Road
Hudson, Ohio 44236 U.S.A.
1-800-321-0183
www.littletikes.com
www.littletikes.co.uk
Pop ‘n Splash Surprise
™
Pop ‘n Splash Surprise
™
Photos are for reference only. Styles may vary from actual contents.
Tool required (not included)
Approx. assembly time: 15 min.
Located in hardware pack
K x6
D.
C.
E. F. G.
A. B.
H. I.
ASSEMBLY PARTS
A. (1) bottom post
B. (1) upper post
C. (1) base
D. (1) top
E. (3) pillar supports
F. (1) foot pedal
G. (1) pump handle
H. (1) hand crank
I. (1) garden hose
connector assembly
J. (21) balls
K. hose adapter
G. (1) pump handle
H. (1) hand crank
I. (1) garden hose
connector assembly
J. (21) balls
J.
K.
6
3
4
5
Open end of hose (I)
1
Thread hose through the bottom of the base (C).
Bottom
of base (C)
Snap crank onto bottom post.
Crank (G)
Foot pedal (F)
Thread hose through (at side) of the foot
pedal (F).
Hose (I)
3
Continue to pull
the hose through
while tting the
foot pedal into
the base.
5
Rotate bottom post and t into the base. IMPORTANT: gently pull on hose to remove slack.
9
As you pull the hose
up, rotate the post to
align the FLAT EDGES
then insert into
bottom post until it
clicks.
FOR STABILITY: the Pop ‘n Splash Surprise™ base should be lled with 40 lbs. (18Kg) of sand (not included)
to prevent tipping and potential injury. The unit may fall over without weight in the base.
1 1
Insert the narrow end of a pillar support,
around the hose and into the top, under the
sprinkler. Push until you hear a click!
14
15
13
Repeat for the remaining 2 pillar
supports.
Sprinkler
Insert hose into the sprinkler.
DO NOT snap collar
down until ALL
pillar supports are
assembled!
10
WARNING:
• Keep these instructions for future reference.
• ADULT ASSEMBLY REQUIRED.
• Constant, competent adult supervision is required when children are playing near water. Do not leave children
unattended.
• This product is intended for use by children 3 years and up. Not suitable for small children
under 36 months due to size.
• Prior to assembly, this package contains small parts: hardware which is a choking hazard and may contain sharp edges
and sharp points. Keep away from children until assembled.
• Do not aim at eyes or face.
• Do not put any foreign objects other than the balls provided on the top assembly.
• This product is intended for outdoor domestic family use only.
• When used outdoors, only use on a grass area. Never use on concrete or hard surfaces.
• Use this product on a level surface and avoid using near swimming pools, on or near steps, hills or inclines.
• Keep area around the product clean, and clear of objects, to prevent slips and falls.
• To prevent tipping and potential injury, do not attempt to stand this unit up without rst lling the base with 40 lbs.
(18Kg) of sand (not included). The unit may fall over without weight in the base.
• Do not allow children to sit, stand play or climb on the top surface. Failure to do so may cause the product to become
unstable.
• Intended for use with water and supplied balls only.
• Never use with anything except clean hose water. Use of other liquids may be harmful or damage the unit.
• Always disconnect and drain hoses and let the unit completely dry before storing.
IMPORTANT INFORMATION
• Please save sales receipt for proof of purchase.
• Thoroughly dry unit before storing. Store out of direct sunlight.
• DISPOSAL: Disassemble and dispose of equipment in such a manner that no hazardous condition such as, but not
limited to, small parts and sharp edges exist at the time the equipment is discarded.
GETTING STARTED
Take a turn and
spin the wheel
Pump the
handle
Turn the crank
Push the
pedal
The “Popper” will
launch anytime after
2 cranks, pumps or
pedal pushes!
Align arrows
17
Align pump handle assembly as shown and insert into the base. Press to t.
Pump handle assembly (E)
16
Pull DOWN
on handles
to set the
“Popper”
4
2
Secure using (4) screws.
7
1
2
Secure using
(2) screws.
6
K x2
8
Position upper post on its side (as
shown). Thread hose through hole
located directly above the bottom of
the upper post and out through the
top.
Hose
Fit into
groove
Slide collar down over pillar
supports until it clicks .
18
Attach a garden hose to the
end of hose assembly.
FOR STABILITY: the Pop ‘n Splash Surprise™ base should
be lled with 40 lbs. (18Kg) of sand (not included) to
prevent tipping and potential injury. The unit
may fall over without weight in the base.
Hose MUST be completely
threaded through post!
1
2
3
4
K x4
To install screws, stand
unit up as shown!
Pull extra
hose out
through
the top
Insert the wide end of the
pillar support into the top
of the upper post where
you see the number 1.
12
NOTE: If needed,
upper post can be
disassembled by
pressing in side
buttons while pulling
upward on post.
2
Hose adapter (K)
ENG