Installation Guide

Fastener locations for attaching floor sheeting to joists. Apply
fasteners on all edges/seams and where lines indicate rim
joist/joists (as shown). Apply fasteners approximately every
8-10 inches. Fastener locations indicated by dashed lines.
Fastener pattern for studs to plates.
Fastener locations for attaching siding to plates and studs. Apply
fasteners on all edges/seams and where lines indicate studs (as
shown). Apply fasteners approximately every 8-10 inches.
Fastener locations indicated by dashed lines.
3. Install floor sheeting (as shown).
1. Layout the side walls (as shown).
2. Install the siding (as shown).
OFS48-96
OFS24-96
Seam
* Front *
* Front *
Walls
* Front *
* Use this layout for both side walls.
ST36
PL24
PL96
* Front *
* Note: 3” overhang
is at the bottom of
the wall.
Side Wall Edge Profile (laying down).
Bottom
Top
* Layout should be done on a flat level surface;
the floor of the coop is a good option.
* Use this layout for both side walls.
SS24-42
SS48-42
Seam