Installation Guide

Fastener locations for attaching shingle ridge caps
(not included in kit) to roof. Apply fasteners (as
shown). These instructions are the same for both
sides. Fastener locations indicated by dashed lines.
9. Install shingle ridge cap (not included in kit – made by installer from shingles) (as shown).
This is one representation of how the finished roof might look.
Shingle tab - ridge cap
profile (top view).
Note: These angles (not
a specific angle) need to
be cut by the installer.
Note: This is a single
shingle tab cut and turned
to lay over the peak.
Note: Center line denotes where
the fold will be. This is an
imaginary line for visualization
purposes only.
Continue this pattern to the end. Place
fasteners in the non-colored area (as
shown). These instructions are the same
for both sides.
Note: The last cap is the only
one that get fasteners in the
colored area.
Note: The last cap gets the
non-colored portion cut off.
Top row of shingles.
* Right *
* Front *