Installation Guide

Fastener locations for attaching roofing to trusses. Apply

fasteners on edges/seams and where lines indicate trusses

(as shown). Apply fasteners approximately every 6-8

inches. These instructions are the same for both sides of

the roof. Fastener locations indicated by dashed lines.

Fastener locations for attaching rakes to front and back walls.

Apply fasteners (as shown) approximately every 6-8 inches.

These instructions are the same for both the front and the

back. Fastener locations indicated by dashed lines.

* Square demonstrates

that the top of the rake

is installed flush/even

with the top of the roof

sheeting.

3. Install the roof sheeting to the trusses (as shown).

4. Install the rakes to the front and back walls (as shown).

* Remove temporary brace just prior to installing the roof

sheeting. Leave the bracing on the second side until you

are ready to install the roof sheeting on that side!

Seam

ORS24-96

ORS24-48

ORS24-24

* Front *

ORS48-96

* Front *

RA72.125

* Front *