Installation Guide

Fastener locations for assembling the remaining trusses.

Apply fasteners at the peak to hold the trusses together

and then into the gusset for structural rigidity (as

shown). Fastener locations indicated by dashed lines.

* Note: the front and back walls have been

hidden in this illustration to better visualize

how the trusses will sit on the side walls.

Fastener locations for attaching the remaining trusses to

the sidewalls (as shown). Fastener locations indicated by

dashed lines.

Roof (shingles and drip edge not included in kit)

1. Assemble the remaining trusses (as shown).

2. Install the trusses to the side walls (as shown).

* Assembly should be done on a flat

level surface, also note there is a

gusset on both sides.

TR72.125

* Note: Brace the trusses to each other

and to the front and back walls (both

sides) until you can install the roof

sheeting (as shown).

* Install fasteners into the

trusses so that they can be

removed without damage to

the truss *

TR72.125

* Temporary bracing

* Right *