Installation Guide

Fastener pattern for studs to plates.

Fastener locations for attaching all back wall parts. Apply

fasteners in all locations (as shown). Angled parts may

require fasteners to be angled so that they properly

penetrate the part that is opposite of it. Fastener locations

indicated by dashed lines.

Fastener locations for attaching siding to plates and studs.

Apply fasteners on all edges/seams and where lines indicate

studs (as shown). Apply fasteners approximately every 8-10

inches. Fastener locations indicated by dashed lines.

8. Lay out the front wall (as shown).

9. Install siding (as shown).

TR72.125

ST36

DH24.5

DST73

* Temporary block

GST24.5

PL31.75

PL33.25

* Layout should be done on a flat level

surface; the floor of the coop is a good option.

Example: Angled fasteners

* Temporary block

* Install fasteners so that they can

be removed without damage to

the plate and the truss *

Fasten gusset to the

trusses (on the side that

will be facing inward)

before installing trusses

to the rest of the wall.

SS24-70.25

SS48-94.5

SS24-71.25

Seam

Front Wall Edge Profile (laying down).