Installation Guide

Fastener pattern for studs to plates.

Fastener locations for attaching all back wall parts. Apply

fasteners in all locations (as shown). Angled parts may

require fasteners to be angled so that they properly

penetrate the part that is opposite of it. Fastener locations

indicated by dashed lines.

fdfffffff

Fastener locations for attaching siding to plates and studs.

Apply fasteners on all edges/seams and where lines indicate

studs (as shown). Apply fasteners approximately every 8-10

inches. Fastener locations indicated by dashed lines.

Back Wall Edge Profile (laying down).

5. Layout the back wall (as shown).

6. Install siding (as shown).

TR72.125

WP18.25

GST38.375

GST24.5

PL91

ST36

CESF13

Example: Angled fasteners

* Layout should be done on a flat level surface;

the floor of the coop is a good option.

Fasten gusset to the

trusses (on the inside)

before installing trusses

to the rest of the wall.

SS24-70.25

SS48-94.5

SS24-71.25

* Truss *

Seam

* Temporary block

GST24.5

* Temporary block

* Install fasteners so that they can be removed

without damage to the plate and the truss.

CETF11