Data Sheet

8
Contact Customer Service
Monday - Friday, 9am - 7pm ET
1-877-250-7729 or [e-mail]
LR3-8060-0b
ONBOARD YOUR LITTER-ROBOT
24. Press and hold the Cycle and Empty buttons until the
Power button goes from white to blue (see Figure
29). Your unit is in WiFi Mode. To exit, press the Reset
button.
Troubleshoot
If the Power button turns blue, then red, make sure
the 4-pin connectors on the wire harness are secured
to the Main Circuit Board and WebConnect module in
the correct orientation.
If the Power button does not turn blue, check that
you have installed the new Main Circuit Board for
Connect. Look for the horizontal white rectangle at
the top of the board, as shown in Figure 30.
Congratulations! You have successfully upgraded your Litter-Robot.
Follow the Connect Quick Start Guide to onboard your Litter-Robot and
connect to the app.
Figure 29
Figure 30
Main Circuit Board for Connect
TEST YOUR WEBCONNECT BOARD INSTALLATION