Data Sheet

6
Figure 24
Figure 25
Figure 23
19. Apply the new black applique. Peel o the backing
and align the inner edge of the applique with the
plastic outline as shown in Figure 24. Press on firmly.
REPLACE THE APPLIQUE
AFFIX THE SERIAL NUMBER STICKER
20. A x the new serial number sticker to the back of
the Base. Place it above the Cat Sensor foot in the
indented area as shown in Figure 25.
WARNING: Do not readjust; sticker reads VOID if
peeled o .
Note: This serial number sticker is required for
onboarding and service of your unit.
18. Remove the blue applique from the front of the
Bezel. Use your fingernail or a utility knife to pry up
the edge, then peel it o .