Data Sheet

14. Make sure the wires attached to the Circuit Board are
tucked behind it in the wire channel (see Figure 19).
5
Figure 18
Figure 19
15. Reassemble the Bezel onto the Circuit Board and
Keypad by holding the Circuit Board upright and
fitting the Bezel over it, so the buttons come through
the Control Panel.
Make sure to keep the Keypad wrapped around the
edges of the Circuit Board.
16. Make sure the edges of the Bezel rest flush with the
Base.
Once in place, look through the opening where the
black Gear protrudes and make sure no wires are
visible. If wires are visible, remove the Bezel, tuck
them into the wire channel, and secure them with
stretchable tape if necessary.
REATTACH THE BEZEL
Figure 20
Figure 21
Figure 22
17. Attach the Bezel by tightening the 5 screws. Do not
overtighten.