Data Sheet

13. Tuck the WebConnect wire harness down into the
wire channel.
4
B. WITH RIBS (see Figure 15):
If your Base has ribs, slide the module into the ribs;
orient the module so the wire connector is at the top
(see Figure 16).
12. Depending on your Base, install the WebConnect
module using one of the following methods:
A. WITHOUT RIBS (see Figure 13):
If your Base does not have ribs, a x the module
to the front wall of the Base with the foam tape
provided (see Figure 14a).
Peel o the backing of the tape, orient the module so
the wire connector is at the top, and press it against
the front wall of the Base as shown in Figure 14b.
Figure 17
Figure 16
Figure 13
Figure 14a
No Ribs
Figure 15
Ribs
Figure 14b