Manual

14
Toll Free: 877-250-7729 www.Litter-Robot.com
2. Cycle Button + [8 Hour Sleep Mode]
Press and Release: Starts a Clean cycle (see page 11).
To pause a cycle, press any button on the Control Panel.
Press Cycle to resume the cycle.
To abort the Clean cycle, press any button to pause the
cycle, then press Empty or Reset to return the Globe to
the Home position.
Press and Hold: Activates 8 Hour Sleep Mode (see page
22).
In Sleep Mode, the yellow light will be on in addition to
the blue standby light. The Cat Sensor will be
deactivated for the next 8 hours and the unit will only
cycle if you press the Cycle button.
Immediately after the 8-hour period, the unit will
perform a Clean cycle, then return to the Home position
with the blue light on. The Cat Sensor will be active
again.
Once set, the 8-hour period repeats every 24 hours. The
start of the period is determined by when the mode is
set initially.
To exit this mode, press and hold the Cycle button until
the yellow light turns off, or, if only the blue light is on
(you are not within the 8-hour sleep period), the yellow
light will flash to indicate you have exited this mode.