Manual

[phone] | www.robotshop.com/ca
8
The Litter-Robot litter sifting system requires clumping litter to work
properly. We recommend a high-quality, clay-clumping litter. Use of
lightweight litters, such as corn or wheat, may require more weight
to activate the Cat Sensor. Litter beads and crystals that are small
enough to pass through the screen will also work (periodic changing
of this type of litter is required).
DO NOT use litters that are the strictly absorbent, non-clumping,
loose-clumping, newspaper-based, or wood-based pellets.
If you are using a litter alternative not listed here, please contact us
at [e-mail] to make sure you are using a compatible
litter.
Tip: When filling the Litter-Robot for the first time, it is best to con-
tinue using the brand of litter you were using previously—as long as
it is a clumping type of litter. Your cat will need to adjust to the new
litter box, and introducing a new litter at the same time may increase
his anxiety. However, if you are currently using a non-clumping litter,
you will need to switch to a clumping type.
Power and Initial Clean Cycle
Plug the small end of the Power Supply into the power input at the
back of the Base. Then plug the AC/DC adapter into a wall outlet.
Locate and press the Power button. The
Litter-Robot will perform an initial Clean
cycle that will last about 2 minutes. Learn
more about the Clean cycle on page 11.
Power Input
Congratulations!
Your Litter-Robot is now ready to use; however, we recommend
powering the unit off until your cat/s become familiar with and begin
using the Litter-Robot.