Manual

[phone] | www.robotshop.com/ca
28
Cleaning the Base
● Never submerge or soak the Base. The Base contains the Cat
Sensor and electronics.
● Wipe the surfaces of the Base with a cloth dampened with a
disinfectant. If using a spray, spray away from the Base directly
onto a cloth or paper towel, so disinfectant does not get on the
electronics.
● Do not use bleach.
Reinstalling the Globe and Bonnet
See diagrams on the next page.
1. Place the Globe on the Base in the approximate Home position
(black lip of the opening at the bottom) with the gear track
aligned with the groove in the Base.
Note: The rotational axis of the Globe is positioned at a 20-de-
gree angle relative to the floor, so the Globe is installed slightly
tilted in the Base.
2. Rotate the black Key at the back of the Globe into the pocket
of the Base.
3. Find the tabs at the bottom and rear of the Bonnet. Align and
insert the tabs into slots in the Base.
4. Rotate the Bonnet downward with light pressure on the sides
such that the Bonnet hugs the Globe. This will help to ensure
proper alignment of the Bonnet snaps with the slots in the Base.
Once the Bonnet snaps have entered the slots, push down on
the Bonnet from the top and make sure the Bonnet snaps have
latched into place and the Bonnet is secure.
Note: The unit will not run without the Bonnet installed.