Manual

[phone] | www.robotshop.com/ca
27
Cleaning the Globe
1. Press the Empty button to cycle the Globe clockwise, which
will allow the litter to fall through the Waste Port and into the
drawer for easy disposal. Sweep any leftover litter toward the
Waste Port. Then, press any button to return the Globe to the
Home position. Ensure that all litter has been removed from the
Globe—wet litter turns into messy clay!
2. Turn the Litter-Robot off and unplug the unit.
3. Remove the Bonnet: Press and release the snap tabs on both
sides of the Bonnet, then lift and rotate the Bonnet off of the
Globe and carefully set it aside.
4. Remove the Globe: With two hands, lift the Globe off the Base.
5. Clean the Globe with water and a mild soap. There are no elec-
tronic components in the Globe that can be damaged by soap
and water. If the Globe has become extremely dirty, it can be
soaked and cleaned with a water hose or power washer.
6. Let the Globe dry completely before reassembling it to the Base
and attaching the Bonnet (see page 28-29).
For a quick touchup, you can use a disposable towelette to wipe the
inside and upper half of the Globe (without removing the litter). The
Litter-Robot can be used immediately, since drying is nearly instanta-
neous.
Cleaning the Waste Drawer
1. Pull the drawer out.
2. Remove the carbon filter.
3. Clean the drawer with soap and water.
4. Make sure the carbon filter is dry before reinstalling it.