Manual

[phone] | www.robotshop.com/ca
23
Wait Time Setting
The Wait Time is the elapsed time starting from when your cat exits
the Globe until the unit starts a Clean cycle. It can be set for 3, 7, or
15 minutes. The default Wait Time is 7 minutes.
Reduce the Wait Time if it is important to minimize odor and/or the
time that waste is available to other pets—such as dogs. However,
reducing the Wait Time may reduce the cleaning effectiveness if
clumps do not have enough time to set up. Extend the Wait Time
when using a lower-quality clumping litter that needs more time to
set up.
Press and hold the Empty button for about 5 seconds to enter Wait
Time Setting mode. One of the lights will start flashing, indicating the
current Wait Time Setting. Use the Reset button to toggle to the next
setting: blue for 3 minutes, yellow for 7 minutes, and red for 15 min-
utes. Press and hold the Empty button to save the setting. The blue
light will blink to confirm, then return to standby.
Control Panel Lockout
Control Panel Lockout disables button functions to prevent unwant-
ed changes. The Litter-Robot functions normally in Automatic Mode
during Control Panel Lockout.
Press and hold the Reset button for about 5 seconds to enter or exit
Control Panel Lockout. The blue light will blink to confirm status.
While in Control Panel Lockout, you can still turn the unit off by
pressing and holding the Power button for 3 seconds.