Manual

[phone] | www.robotshop.com/ca
20
unit, including emptying the Waste Drawer, adding or removing litter
from the Globe, or cleaning or moving the unit. When you are done,
turn the unit back on. The Litter-Robot will perform an initial Clean
cycle and the Cat Sensor will take a new measurement of the unit’s
weight.
The Reset button is another way to reset the Cat Sensor after doing
anything that affects the unit’s weight. Press Reset firmly and quickly,
then watch for the blue light to flash to confirm you have reset the
Cat Sensor. Be careful not to rest on the unit as you press the button
or your weight will influence the reading.
Drawer Full Indicator (DFI)
The Litter-Robot is equipped with
infrared emitters and sensors
located above the Waste Drawer
that check if the drawer is full each
time the Globe returns to the Home
position. The Control Panel displays
a flashing blue light when the DFI is
activated. Upon the first activation
of the DFI, the blue light flashes,
and the Cat Sensor remains active.
Upon the third activation of the DFI
(after two more Clean cycles), the
Cat Sensor deactivates and the unit will no longer cycle automatically.
Check or empty the Waste Drawer, then press Reset to cancel the
indicator and reset the Cat Sensor.
Automatic Night Light
Although cats generally have excellent vision, aging and illness can
diminish their ability to see in low light conditions. The Automatic
Night Light, located in the upper Bonnet, is there to help guide your
cat to the litter box. A light sensor located above the Cycle button
turns the Night Light on and off automatically. Turn the Night Light
function on and off by pressing and holding the Power button (see
Control Panel - Buttons section, Power Button, page 13).
Drawer Full Indicators