Manual

[phone] | www.robotshop.com/ca
17
Control Panel - Indicator Lights
Blue Light On: OK/Standby
The unit is OK and ready for your cat’s next use.
Blue Light Flashing: Waste Drawer is Full
The Waste Drawer is approaching full (see page 20). Remove the
waste, install a new liner, then press Reset to cancel the flashing light
and adjust the Cat Sensor.
Blue and Yellow Lights On: Sleep Mode
The Litter-Robot is in 8-Hour Sleep Mode (see page 22).
Yellow Light On: Cycling/In Use
The Litter-Robot is cycling (Clean or Empty cycle).
Yellow Light Flashing: Cycle Interrupted
A yellow light flashing slowly (about once per second) indicates a
cycle has been interrupted by one of the following:
● While cycling, if the Cat Sensor is activated by a cat entering
the Globe, the unit will stop and the yellow light will flash. The
unit will start to cycle again 15 seconds after your cat has left
the Globe.
● If the Bonnet is removed while cycling or while the Globe is
at the Home position, the unit will stop (if previously cycling)
and the yellow light will flash. The unit will resume its previous
function 5 seconds after the Bonnet is replaced (see page 28-
29).
A yellow light flashing quickly (about four times per second)
indicates a cycle has been interrupted by the Anti-Pinch Safety
Feature (see page 30). While cycling, if a potential pinch condition
is detected, the Globe will stop and reverse direction for 2 seconds.
The yellow light will begin flashing quickly, awaiting your action. Once
the blockage is cleared, press any button to return the Globe to the
Home position.