Manual

[phone] | www.robotshop.com/ca
14
Cycle Button + [8-Hour Sleep Mode]
Press and Release: Starts a Clean cycle (see page 11).
To pause a cycle, press any button on the Control Panel. Press Cycle
to resume the cycle.
To abort the Clean cycle, press any button to pause the cycle, then
press Empty or Reset to return the Globe to the Home position.
Press and Hold: Activates 8-Hour Sleep Mode (see page 22).
In Sleep Mode, the yellow light will be on in addition to the blue
standby light. The Cat Sensor will be deactivated for the next 8 hours
and the unit will only cycle if you press the Cycle button.
Immediately after the 8-hour period, the unit will perform a Clean cy-
cle, then return to the Home position with the blue light on. The Cat
Sensor will be active again.
Once set, the 8-hour period repeats every 24 hours. The start of the
period is determined by when the mode is set initially.
To exit this mode, press and hold the Cycle button until the yellow
light turns off, or, if only the blue light is on (you are not within the
8-hour sleep period), the yellow light will flash to indicate you have
exited this mode.
Cycle Button