Manual
(450) 420-1446 | www.robotshop.com/ca
11
Clean Cycle
After your cat leaves the Globe, the Litter-Robot automatically
performs a Clean cycle. The patented sifting system separates
the clumps from the clean litter and deposits them into the Waste
Drawer below. It takes about 2 minutes. You can also press the Cycle
button to start a Clean cycle.
During a Clean cycle, press any button to pause the cycle. Press the
Cycle button to resume the cycle. Press the Reset or Empty button
to abort the cycle and return the Globe to the Home position.
How it works:
The Litter-Robot is ready for use when the Globe is at the Home po-
sition and the blue light on the Control Panel is on.
1. When a cat enters the Globe, the Cat Sensor is activated; the
blue light turns off and the red light turns on.
2. Once the cat exits the Globe, the countdown to a Clean cycle
begins. When the Wait Time (see page 23) has elapsed, the
red light turns off and the yellow light turns on as a Clean cycle
begins.
3. The Globe rotates counterclockwise. The yellow light will be on
while cycling.
4. During rotation, a weight behind the black rubber Globe lin-
er causes the liner to fall away from the Globe to ensure any
stuck-on clumps are removed.
5. The screen passes through the litter, separating the clumps
from the clean litter. The clean litter is collected in a chamber
behind the screen.
6. As the Globe rotates to Dump position, the waste clumps fall
through the Waste Port in the Waste Drawer.
7. The Globe then rotates clockwise, toward the Home position.
The Globe liner will fall back into place and the clean litter will
spill back into the litter bed.
8. The Globe will rotate past the Home position to level the litter
before finally returning to the Home position. The yellow light
turns off and the blue standby light turns on.