Manual

[phone] | www.robotshop.com/ca
10
Ongoing Maintenance
Empty the Waste Drawer when indicated by the flashing blue light
on the Control Panel.
How often you will need to empty the Waste Drawer depends on the
number and size of your cats. For two average-sized cats, twice per
week is typical. For a single cat, once per week is usually sufficient.
Pull out the Waste Drawer using the handle below the step, then
gather the edges of the liner bag and dispose.
You can use Litter-Robot custom-fit, biodegradable Waste Drawer
Liners or any 38-49-liter trash bags.
To install a new drawer liner, open the bag and roll down the edge
about four times. Starting at the back of the drawer, push the rolled
edge of the bag into each of the four tabs, keeping the bag taut as
you work forward. Slide the drawer back in, being careful not to push
the unit against the wall or into a corner (must not be touching any
walls). Then, press the Reset button to reset the Cat Sensor.
Add litter as needed.
Check the litter level once per week or each time you empty the
Waste Drawer. Add just enough litter to meet the raised Fill Line
inside the Globe, and be careful not to overfill it. After adding or re-
moving litter, press the Reset button to reset the Cat Sensor.
Press the Reset button.
Any time you affect the weight or placement of the unit (including
emptying the Waste Drawer, adding or removing litter, or cleaning or
moving the unit), press the Reset button to ensure the Cat Sensor will
detect your cat and cycle properly.
See Use and Care on page 25 to learn about the Carbon Filter, Base
Seal Strips, Waste Drawer Liners, and how to clean the Litter-Robot.