Manual

6
Reach down along the sides of the unit and find the hand holds
on the base unit and lift the whole unit out of the box. The unit
weighs 24 lbs. Try to avoid cutting open or damaging the outer
box as you may need it later.
Remove card board spacers between the Bonnet and Globe.
If possible, place the Litter-Robot in the same location as the old
litter box. Make sure the Litter-Robot is on a level, firm surface.
1. Fill the Globe with litter. The Litter-Robot litter sifting
system requires a clumping type litter to work properly.
We recommend a high quality clay-based clumping litter
such as Litter-Robot™ brand premium clumping litter. Litter
beads, and crystals may also be used with the Litter-Robot
as long as the beads and crystals are small enough to pass
through the screen – periodic changing of this type of litter
is required. Litters that DO NOT work in the Litter-Robot
are the strictly absorbent, non-clumping litters, newspaper
based litters, loose clumping litters, and absorbent wood-
based pellets. If you are using a litter alternative not listed
Toll Free: 877-250-7729 www.Litter-Robot.com