Manual

37
Troubleshooting
Please also visit:
http://litterrobot.kayako.com/Troubleshooter/List
Yellow-> Red LEDs flashing sequentially:
Motor has detected an obstruction or jammed condition.
Turn unit OFF then back ON to reset.
Red LED Flashing:
Cat Sensor has been activated continuously for more than 2
minutes. Check for excess weight, such as too much litter or
waste. Press the Reset button or turn unit OFF then back
ON to reset Cat Sensor.
Yellow LED Flashing:
Once per second: The cycle has been interrupted. This
happens when the Cat Sensor is activated during the clean
cycle or if the Bonnet is removed. Globe will stop cycling for
15 seconds. If after 15 seconds, interruption is no longer
present, Globe will resume cycling with yellow LED on.
Twice per second: Pinch Detection has been activated. Unit
will stop, reverse and after 1 minute will attempt to
complete cycle again.
Blue LED Flashing:
The Blue LED will flash to indicate the Waste Drawer is full.
Check or empty the Waste Drawer and press the Reset
button.
Blue and Yellow LEDs On:
Litter-Robot is in 8 hour lockout mode. Cat sensor will be
de-activated and unit will only cycle if Cycle button is
manually pressed. This will happen every 24 hours based on
the time of initial setting.
Toll Free: 877-250-7729 www.Litter-Robot.com