Manual

26
2. Rotate Key at back of Globe into pocket of Base. The
Key controls the motion of the internal Shield and needs
to be in the Base pocket to function properly.
3. Find tabs at bottom and rear of Bonnet and align/insert
tabs into small holes in Base.
4. Rotate Bonnet downward with light pressure on the
sides such that Bonnet hugs the Globe. This will help to
ensure proper alignment of Bonnet snaps with the slot
openings in the Base. Once Bonnet snaps have entered
the slots, push down on the Bonnet from the top and
make sure that the Bonnet snaps have latched into place
and Bonnet is secure. Note that the unit will not run
without the Bonnet installed.
(See next page for diagram)
Toll Free: 877-250-7729 www.Litter-Robot.com