Manual

20
The 8 hour period is repeated every 24 hours. The start of the 8
hour period is determined by when the mode was initially set.
To start this mode, at the desired time, press and hold the Cycle
button until the yellow LED lights up. Both yellow and blue LEDs
will be lit now, and during the next 8 hours indicating the unit is
in 8 Hour Sleep Mode.
When the 8 hour period has expired, the unit will run a clean
cycle. Once the Globe has returned to home position, only the
blue LED will be on. Once the 8 hour sleep period begins again
automatically, both yellow and blue LEDs will be on again.
To exit this mode press and hold the Cycle button until the
yellow LED turns off, or if only the blue LED is on (not within the
8 hour sleep period), the yellow LED will flash and then turn off
indicating you have exited from this mode.
Wait Time Setting
The elapsed time starting from your cat exiting the unit to when
the unit runs a clean cycle can be set for three, seven, and
fifteen minutes. Seven minutes is the default setting.
It may be useful to reduce the wait time if it is important to
minimize odor and/or the time that the waste is available to
other pets - such as dogs. However, reducing the wait time may
reduce the cleaning effectiveness (clumps do not have enough
time to set up).
Extending the wait time may be desirable when using a lower
quality clumping litter that needs more time to set up.
Press and hold the Empty button to enter the Wait Time Setting
mode. One of the LEDs will be flashing indicating the current
Wait Time Setting. Use the Reset button to toggle to the next
setting/s. Press and hold the Empty button to save the setting.
Toll Free: 877-250-7729 www.Litter-Robot.com