Manual

12
2. If the Night Light function is deactivated and the
ambient light levels are high (day light) the light will flash
on then off indicating Night Light function has been
activated. In low ambient light (dark room) the light will
come on and stay on.
The status of the Night Light function can be checked at
any time by covering the light sensor, located above the
Cycle button on the Control Panel, to see if the Night Light
comes on or not.
Night Light settings are remembered when the unit is
powered Off and back On again.
2. Cycle Button + [8 Hour Sleep Mode]
Press and Release: Pressing the Cycle Button starts the
Litter-Robot cleaning cycle. In order to pause the cycle,
press any button on the Control Panel during the Clean
Cycle. Press Cycle once again to resume the cleaning cycle.
To stop and abort the Clean Cycle, press any button to
pause the cycle, then press either Empty or Reset buttons
to return the Globe to the Home Position.
Press and Hold: Holding the Cycle button will activate the 8
Hour Sleep Mode. When activated, the yellow LED will
light up in addition to blue LED. Cat Sensor will be de-
activated for the next 8 hours and unit will only cycle if
Cycle button is manually pressed during this 8 hour window.
Immediately after 8 hours, the unit will perform a cleaning
cycle and then return to the home position with only the
blue LED on and operate with the Cat Sensor active. The 8
Hour Sleep Mode period (Cat Sensor deactivated) will be
Toll Free: 877-250-7729 www.Litter-Robot.com