Cut Sheet
Table Of Contents
- Table of Contents
- 1. General
- 2. Operation
- 2.1 Settings
- 2.2 Calibration
- 2.3 Trip Indication and Reset
- 2.4 Remote Operation
- 2.5 Relay K1 LED
- 2.6 Unit Healthy Output
- 2.7 Diagnostic LED
- 2.8 Analog Output
- 3. Installation
- 4. Data Interfaces
- 5. Troubleshooting
- 6. Technical Specifications
- 7. Ordering Information
- 8. Warranty
- 9. Test Procedures
- Appendix A SE-330HV Revision History
Page 36
SE-330HV Neutral-Grounding-Resistor Monitor Rev. 5-I-091115
FIRMWARE REVISION 2.50
Added support for adjustable resistor-fault trip level.
Web page functionality re-enabled for Ethernet options.
F
IRMWARE REVISION 2.40
Added support for geo-magnetic filter.
Added support for 12 to 60 s resistor-fault trip time.
Improved log file descriptions.
IEC 61850 GOOSE network input support now always enabled.
Improved compatibility for Modbus TCP.
Web page disabled for Ethernet options. This will be enabled in a future firmware release.
IP setting changes for Ethernet options now require power cycle to take effect.
F
IRMWARE REVISION 2.31
SD Card and USB diagnostic events no longer cause a trip.
F
IRMWARE REVISION 2.30
Remote calibration feature added.
F
IRMWARE REVISION 2.20
Added support for EtherNet/IP protocol.
IED name now reported correctly through IEC 61850 interface.
EtherNet/IP and Modbus communications card LED status updated.
Hardware version viewable in the SE-MON330 software and through the Modbus and IEC 61850 servers.
FIRMWARE REVISION 2.10
Added support for IEC 61850 and DeviceNet protocols.
F
IRMWARE REVISION 2.08
Updated firmware to include USB and microSD™ interfaces, datalogging, and firmware update via microSD™.
K2 and K3 indication relays can be configured for fail-safe or non-fail-safe operation.
Trip records increased to 100 with date and time stamping.
Added support for communications options.