Cut Sheet
Table Of Contents
- Table of Contents
- 1. General
- 2. Operation
- 2.1 Settings
- 2.2 Calibration
- 2.3 Trip Indication and Reset
- 2.4 Remote Operation
- 2.5 Relay K1 LED
- 2.6 Unit Healthy Output
- 2.7 Diagnostic LED
- 2.8 Analog Output
- 3. Installation
- 4. Data Interfaces
- 5. Troubleshooting
- 6. Technical Specifications
- 7. Ordering Information
- 8. Warranty
- 9. Test Procedures
- Appendix A SE-330HV Revision History
Page 26
SE-330HV Neutral-Grounding-Resistor Monitor Rev. 5-I-091115
PROBLEM DIAGNOSTIC LED
FLASH CODE
(1)
SOLUTION
No analog-output current. The output at terminals 19 and 20 requires a voltage source. See
Fig. 2 for analog-output connections. See Section 9.3 for the
analog-output tests.
NOTES:
(1)
L = long pause, S = short flash.
(2)
When LED is on, corresponding indication relay is energized when in the non-fail-safe mode or de-energized when in
the fail-safe mode.