Cut Sheet
Table Of Contents
- Table of Contents
- 1. General
- 2. Operation
- 2.1 Settings
- 2.2 Calibration
- 2.3 Trip Indication and Reset
- 2.4 Remote Operation
- 2.5 Relay K1 LED
- 2.6 Unit Healthy Output
- 2.7 Diagnostic LED
- 2.8 Analog Output
- 3. Installation
- 4. Data Interfaces
- 5. Troubleshooting
- 6. Technical Specifications
- 7. Ordering Information
- 8. Warranty
- 9. Test Procedures
- Appendix A SE-330HV Revision History
Page 11
SE-330HV Neutral-Grounding-Resistor Monitor Rev. 5-I-091115
INSTALL O-RING INTO
GROOVE IN THE REAR
OF WEATHERPROOF
WINDOW
INSERT THE SE-330HV THROUGH OPENING
OF THE WEATHERPROOF WINDOW, UNTIL IT
IS SECURELY NESTED TO THE BACK OF THE
DARK GREY PVC PANEL.
INSTALL O-RING INTO THE GROOVE IN THE REAR
OF WEATHERPROOF WINDOW ASSEMBLY.
INSERT ASSEMBLY INTO PANEL AND FASTEN WITH
THE HARDWARE PROVIDED WITH THE SE-330HV.
FRONT-PANEL
DETAILS NOT SHOWN.
FIGURE 7. SE-IP65CVR-G Weatherproof Cover Installation.