Technical Specifications

Wafer Static LED Recessed Downlight
WF6E
6" LED Module
IC/Non-IC
New Construction/Remodel
Specications
Aperture: 4.9 (12.4)
Ceiling opening: 6 (15.2)
Overlap trim: 6.7 (17)
Height: 1.1 (2.8)
Weight 1lbs
FEATURES & SPECIFICATIONS
INTENDED USE — The 6" Wafer-Thin LED recessed downlight with remote driver box combines high
quality light output and eciency while eliminating the need for a recessed housing. The innovative,
slim design allows for easy retrot, remodel or new construction installation from below the ceiling. The
Wafer downlight provides general illumination in residential and commercial applications including multi-
family and hospitality. Ideal for use in living and dining areas, bedrooms, closets, hallways, bathrooms,
showers, kitchens, basements, sots, entryways and porches. The Wafer LED downlight is wet location
listed – making it ideal for use in a breadth of outdoor residential, hospitality, commercial and multifamily
applications.
CONSTRUCTION — Die cast aluminum mounting frame with integral polycarbonate ange provides
passive thermal cooling achieving L70 at 50,000 hours. Non-conductive dead-front trim design suitable for
a wide range of applications and codes requiring a non-conductive lens assembly. IC rated driver and xture
- approved for direct contact with insulation. FT4 plenum rated cable connector to connect from module to
remote driver box. Isolated driver integrated inside steel remote box with four 7/8" knockouts with slots for
pryout. Suitable for pulling wires with the 12 cubic-inch wiring compartment to accommodate up to (6) 14
gauge insulated conductor, or (4) 12 gauge insulated conductors; making the Wafer LED Downlights much
easier to wire in 2in/2out (plus ground) daisy-chain applications and contractor friendly. Wire nuts included.
INSTALLATION — Ideal for shallow ceiling plenum; no housing required. Steel spring clip for easy
installation. 6" cut out template provided to ensure correc t sized hole is cut into ceiling for proper installation
of the trim. Size of hole should not exceed 6 1/4 inches for this product. Suitable for installation in t-grid
and drop ceiling applications with the WF8643 Pan. 2" plenum space required for installation of the remote
driver box.
OPTICS — Edge-lit LED technology uses light guided plate to distribute light. Polycarbonate lens provides
even illumination throughout the space. Utilized 3000K and 4000K color temperature LEDs binned within
3-step MacAdam ellipse, 90 CRI.
ELECTRICAL — Connect directly to 120V power supply via provided UL recognized driver. High ecient
driver with power factor > 0.9. Ambient operating temperature: -4F (-40°C) to +104°F (+4C). Dimming
down to 10% (See page 2 for recommended dimmers).
LISTINGS — CSA certied to US and Canadian safety standards. ENERGY STAR® certied product. Wet
location. Air Tight certied in accordance with ASTM E283-2004. NOM Certied. Can be use for State of
California Title 24 high ecacy LED compliance under JA8, reference Modernized Appliance Eciency
Database System (MAEDBS) for 2016 JA8 High Ecacy Lighting.
WARRANTY — 5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/support/customer-support/terms-and-conditions
Note: Actual performance may dier as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
DOWNLIGHTING WF6E
D
I
M
M
A
B
L
E
Catalog
Number
Notes
Type
[17cm]
6.7in
[14.98cm]
5.9in
[12.40cm]
4.9in
[1.11cm]
.4in
[2.86cm]
1.1in
All dimensions are inches (centimeters)
unless otherwise indicated.
WF6E
Series Lamp CCT/W/Lumens
1
CRI Finish Package Quantity
WF6E 6" wafer-thin LED downlight LED LED 30K 3000K/11.2W/790L
40K 4000K/11.2W/840L
90CRI 90 CRI MW Matte White CP6 6 units per carton
ORDERING INFORMATION
Example: WF6E LED 30K 90CRI MW CP6
Accessories: Order as separate catalog number.
WF6 PAN R12 6" new construction pan, retail pack of 12
WF8643 PAN U Universal new construction pan, unit pack
WFJB U Remodel Joist Bar
WFEXC6 U 6' 2 pin FT4 cable
WFEXC10 U 10' 2 pin FT4 cable
WFEXC20 U 20' 2 pin FT4 cable
WF6GR MW JZ 6" round oversized trim ring
Notes
1 Total system delivered
lumens.
WF6 PAN
Remodel Joist Bar
Extension Cable
(2-pin)
WF8643 Pan
Only compatible with single layer sheet rock.

Summary of content (2 pages)