Cut Sheet

One Lithonia Way, Conyers, GA 30012 | 1-800-705-SERV (7378) | www.Acuitybrands.com
© 2020-2022 Acuity Brands Lighting, Inc. All rights reserved. Rev. 02/02/22 Page 2 of 2
CONTRACTOR SELECT WF6E STATIC LED
Light and Commercial Residential
INTENDED USE:
The 6" Wafer-Thin LED recessed downlight with remote driver box combines high quality
light output and efciency while eliminating the need for a recessed housing. The innovative,
slim design allows for easy retrot, remodel or new construction installation from below the
ceiling. The Wafer downlight provides general illumination in residential and commercial
applications including multi-family and hospitality. Ideal for use in living and dining areas,
bedrooms, closets, hallways, bathrooms, kitchens, basements, softs, entryways and porches.
The Wafer LED downlight is wet location listed – making it ideal for use in a breadth of
outdoor residential, hospitality, commercial and multifamily applications. Non-conductive
dead-front trim design suitable for a wide range of applications and codes requiring a non-
conductive lens assembly.
CONSTRUCTION:
Die cast aluminum mounting frame with integral polycarbonate ange provides passive
thermal cooling achieving L70 at 50,000 hours. IC rated driver and xture - approved for
direct contact with insulation. FT4 plenum rated cable connector to connect from module to
remote driver box. Isolated driver integrated inside steel remote box with four 7/8" knockouts
with slots for pryout. Suitable for pulling wires with the 12 cubic-inch wiring compartment to
accommodate up to (6) 14 gauge insulated conductor, or (4) 12 gauge insulated conductors;
making the Wafer LED Downlights much easier to wire in 2in/2out (plus ground) daisy-chain
applications and contractor friendly. Wire nuts included.
ELECTRICAL:
Connect directly to 120V power supply via provided UL recognized driver. High efcient driver
with power factor > 0.9. Ambient operating temperature: -40°F (-40°C) to +104°F (+40°C).
Dimming down to 10% (See page 2 for recommended dimmers).
INSTALLATION:
Ideal for shallow ceiling plenum; no housing required. Steel spring clip for easy installation.
6" cut out template provided to ensure correct sized hole is cut into ceiling for proper
installation of the trim. Size of hole should not exceed 6 1/4 inches for this product. Suitable
for installation in t-grid and drop ceiling applications with the WF8643 Pan. 2" plenum space
required for installation of the remote driver box.
LISTINGS:
CSA certied to US and Canadian safety standards. ENERGY STAR® certied product. Wet
location. Air Tight certied in accordance with ASTM E283-2004. NOM Certied. Can be use
for State of California Title 24 high efcacy LED compliance under JA8, reference Modernized
Appliance Efciency Database System (MAEDBS) for 2016 JA8 High Efcacy Lighting.
WARRANTY:
5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/support/warranty/terms-and-conditions
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
Specifications Dimensions
All dimensions are inches (centimeters)
unless otherwise indicated.
Aperture: 4.9 (12.4)
Ceiling opening: 6 (15.2)
Overlap trim: 6.7 (17)
Height: 1.1 (2.8)
2.86cm
1.1in
1.11cm
.4in
14.98cm
5.9in
17cm
Ø
6.7in
12.40cm
Ø
4.9in