Technical Specifications

Wafer Static LED Recessed Downlight
WF4E
4" LED Module
IC/Non-IC
New Construction/Remodel
Specications
Aperture: 3.2 (9.06)
Ceiling opening: 4 (10.40)
Overlap trim: 4.7 (12)
Height: 0.4 (1.11)
Weight 0.8lbs
FEATURES & SPECIFICATIONS
INTENDED USE — The 4" Wafer-Thin LED recessed downlight with remote driver box combines high
quality light output and eciency while eliminating the need for a recessed housing. The innovative,
slim design allows for easy retrot, remodel or new construction installation from below the ceiling. The
Wafer downlight provides general illumination in residential and commercial applications including multi-
family and hospitality. Ideal for use in living and dining areas, bedrooms, closets, hallways, bathrooms,
showers, kitchens, basements, sots, entryways and porches. The Wafer LED downlight is wet location
listed - making it ideal for use in a breadth of outdoor residential, hospitality, commercial and multifamily
applications.
CONSTRUCTION — Die cast aluminum mounting frame with integral polycarbonate ange provides
passive thermal cooling achieving L70 at 50,000 hours. Non-conductive dead-front trim design suitable for
a wide range of applications and codes requiring a non-conductive lens assembly. IC rated driver and xture
- approved for direct contact with insulation. FT4 plenum rated cable connector to connect from module to
remote driver box. Isolated driver integrated inside steel remote box with four 7/8" knockouts with slots for
pryout. Suitable for pulling wires with the 12 cubic-inch wiring compartment to accommodate up to (6) 14
gauge insulated conductor, or (4) 12 gauge insulated conductors; making the Wafer LED Downlights much
easier to wire in 2in/2out (plus ground) daisy-chain applications and contractor friendly. Wire nuts included.
INSTALLATION — Ideal for shallow ceiling plenum; no housing required. Steel spring clip for easy
installation. 4" cut out template provided to ensure correct sized hole is cut into ceiling for proper
installation of the trim. Size of hole should not exceed 4 1/4 inches for this product. Suitable for installation
in t-grid and drop ceiling applications with the WF8643 Pan. 3" plenum space required for installation of
the remote driver box.
OPTICS — Edge-lit LED technology uses light guided plate to distribute light. Polycarbonate lens provides
even illumination throughout the space. Utilized 3000K and 4000K color temperature LEDs binned within
3-step MacAdam ellipse, 90 CRI.
ELECTRICAL — Connect directly to 120V power supply via provided UL recognized driver. High ecient
driver with power factor > 0.9. Ambient operating temperature: -40°F (-40°C) to +104°F (+4C). Dimming
down to 10% (See page 2 for recommended dimmers).
LISTINGS — CSA certied to US and Canadian safety standards. ENERGY STAR® certied product. Wet
location. Air Tight certied in accordance with ASTM E283-2004. NOM Certied. Can be use for State of
California Title 24 high ecacy LED compliance under JA8, reference Modernized Appliance Eciency
Database System (MAEDBS) for 2016 JA8 High Ecacy Lighting.
WARRANTY — 5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/support/customer-support/terms-and-conditions
Note: Actual performance may dier as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
DOWNLIGHTING WF4E
D
I
M
M
A
B
L
E
Catalog
Number
Notes
Type
[12cm]
4.7in
[10.40cm]
4.1in
[8.06cm]
3.2in
[1.11cm]
.4in
[2.86cm]
1.1in
WF4E
Series Lamp CCT/W/Lumens
1
CRI Finish Package Quantity
WF4E 4" wafer-thin LED downlight LED LED 30K 3000K/8.1W/580L
40K 4000K/8.1W/600L
90CRI 90 CRI MW Matte White CP6 6 units per carton
ORDERING INFORMATION
Example: WF4E LED 30K 90CRI MW CP6
Accessories: Order as separate catalog number.
WF4 PAN R12 4" new construction pan, retail pack of 12
WF8643 PAN U Universal new construction pan, unit pack
WFJB U Remodel Joist Bar
WFEXC6 U 6' 2 pin FT4 cable
WFEXC10 U 10' 2 pin FT4 cable
WFEXC20 U 20' 2 pin FT4 cable
WF4GR MW JZ 4" round oversized trim ring
Notes
1 Total system delivered
lumens.
WF4 PAN
Remodel Joist Bar
Extension Cable
(2-pin)
WF8643 Pan
Only compatible with single layer sheet rock.
All dimensions are inches (centimeters)
unless otherwise indicated.

Summary of content (2 pages)