Installation Guide
Table Of Contents
Installaon Instrucons
TWX
Lithonia Lighng Outdoor
One Lithonia Way, Conyers, GA 30012
Phone: 1-800-705-SERV (7378)
www.lithonia.com
Part Number: 912-00181-001 REV A
Revision Date: 11-25-20
©2019-2020 Acuity Brands Lighng, Inc.
All Rights Reserved.
Surface conduit applicaon:
1. Loosen the 2 capve screws in the front housing,
using the 1/8” Allen wrench.
2. Separate the front door from the back housing.
The door needs to be opened more than 90° to
disengage the hinges. Set the door aside on a clean
surface, to avoid any damage or scratches.
3. Prepare the back housing for installaon by re-
moving the appropriate conduit plug (gure 2) and
mounng knock out holes as needed. Be careful not
to touch the LEDs or damage the internal compo-
nents in any way.
4. Install the back housing directly to the wall using
the wall anchor holes and appropriate screws (not
provided).
5. Caulk the mounng holes to prevent moisture
entry.
6. Thread the conduit into the housing conduit hole.
Use thread sealant to keep the housing waterght.
7. Make supply connecons.
8. If provided with an ALO device, adjust the dial to
the required lumen level (use the ALO label on the
backside of the door as reference), by turning it us-
ing a small at head screwdriver.
9. Replace front cover. Make sure the hinges are
engaged properly.
10. Tighten the 2 capve screws (30-35in lbs). Do
not over ghten. Over ghtening will cause stripping
and void all warranes.
Troubleshoong: If this xture fails to operate properly, check to make sure: • The xture is wired correctly. • There
are no loose connecons. • The xture is grounded correctly. • The line voltage at the xture is correct. If all these
variables have been checked and the xture sll does not operate as specied, contact your local Lithonia Lighng
distributor.
Fig. 2. Conduit entry locaons
1/2" CONDUIT PLUGS