Installation Guide

ManualsBrandsLithonia Lighting ManualsLightingContractor Select TWX 100-Watt Equivalent Integrated LED Dark Bronze Dusk to Dawn Wall Pack Light Slim Profile, 4000K

Table Of Contents

Installaon Instrucons

TWX

DELIVERY: Upon receipt of xture and accessories (packed separately), thoroughly inspect for

any freight damage. All damage should be reported to the delivery carrier. Compare the catalog

descripon listed on the packing slip with the xture label on the inside of the housing to be sure

you have received the correct merchandise.

This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two

condions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operaon.

5 year limited warranty

Lithonia Lighng Outdoor

One Lithonia Way, Conyers, GA 30012

Phone: 1-800-705-SERV (7378)

www.lithonia.com

Part Number: 912-00181-001 REV A

Revision Date: 11-25-20

Tools Required: 1/8" Allen wrench

Installing the luminaire:

9.31

13.33

4.38

1.45

1.20

1/2" DIA. K.O.

1. Loosen the 2 capve screws in the front housing, us-

ing the 1/8” Allen wrench.

2. Separate the front door from the back housing. The

door needs to be opened more than 90° to disengage

the hinges. Set the door aside on a clean surface, to

avoid any damage or scratches.

3. Prepare the back housing for installaon by removing

the center knock out and mounng knock out holes as

needed. Be careful not to touch the LEDs or damage the

internal components in any way.

4. Feed the supply wires through the center knock out

hole.

5. Install the back housing directly to the wall (recom-

mended) using the wall anchor holes and appropriate

screws (not provided). When installing to a juncon box,

make sure it is rated for the weight of the luminaire.

6. Caulk the mounng holes to prevent moisture entry.

7. Make supply connecons.

8. If provided with an ALO device, adjust the dial to the

required lumen level (use the ALO label on the backside

of the door as reference), by turning it using a small at

head screwdriver.

9. Replace front cover. Make sure the hinges are en-

gaged properly.

10. Tighten the 2 capve screws (30-35in lbs). Do not

over ghten. Over ghtening will cause stripping and

void all warranes.

Fig. 1.