Specification

One Lithonia Way, Conyers, GA 30012 | 800-705-SERV (7378) | www.lithonia.com
© 2018-2020 Acuity Brands Lighting, Inc. All rights reserved. Rev. 08/17/20 Page 2 of 2
CONTRACTOR SELECT TWS LED
INTENDED USE:
The TWS LED combines traditional wall pack design with high-output LEDs to provide an
energy efcient, low maintenance LED wall pack suitable for replacing up to 70W HPS or
100W MH xtures. The traditional shape helps maintain building aesthetics when replacing
only a portion of your building’s wall packs. TWS LED is for outdoor applications such as
personnel doors, loading areas, driveways and parking areas.
CONSTRUCTION:
Back plate is die-cast aluminum. Front cover is impact-resistant polycarbonate which is fully gasketed.
All electronics are protected in the upper housing. Housing is sealed against moisture and environmen-
tal contaminants.
FINISH:
UV stabilized polycarbonate front cover has dark bronze color which provides superior resistance to
corrosion and weathering and that can withstand extreme climate changes without cracking or peeling.
OPTICS:
Protective polycarbonate lens covers the LEDs. Prismatic front cover and precision-molded reflector for
superior uniformity and fixture spacing. Light engine is available in 5000K (80 min. CRI).
ELECTRICAL:
Light engine consists of two high-powered, long-life, high-efficacy LEDs mounted on an internal
aluminum heat sink to maximize heat dissipation and promote long life L70/50,000 hours at 40°C).
Driver and integral photocell operate at 120V and are fully enclosed in the upper housing. There are no
user serviceable parts.
INSTALLATION
Back housing easily mounts to any recessed junction box. With all electronics in upper housing the open
lower section makes wiring easy. Mount on any vertical surface. Not recommended in applications where a
sprayed stream of water can come in direct contact with polycarbonate lens.
LISTINGS:
UL Certified to US and Canadian safety standards for wet-location mounting higher than 4 feet off the
ground.
DesignLights Consortium® (DLC) qualied product. Not all versions of this product may be
DLC qualied. Please check the DLC Qualied Products List at www.designlights.org/QPL to
conrm which versions are qualied.
Rated for -40°C to 40°C ambient temperature.
WARRANTY:
5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/support/customer-support/terms-and-conditions
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
Specifications
Dimensions
TWS LED WALL PACK
Height: 10-7/8" (27.7cm)
Width: 6-3/4" (17.2cm)
Depth: 5-5/16" (13.5cm)
Weight: 3.19 lbs (1.45 kgs)
All dimensions are inches (centimeters)
unless otherwise indicated.