Installation Guide

page 4
4. Pull house supply wires through access hole into rear
housing and secure rear housing to junction box with two
mounting screws (7) Note: make sure no wires are pinched
before tightening screws or secure the rear housing to wall
in appropriate method. Note: Assure that xture is mounted
onto a structurally sound surface and use mounting hardware
appropriate for your application.
For Wet Location compliance, xture must be properly
sealed! For moisture seal apply silicone caulking between the
mounting surface and rear housing as well as around sides
of rear housing.
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned o.
5. Ground xture using wire nut to connect the (copper or green)
house supply ground wire & the green xture ground wire. Note:
If house wiring does not include a ground wire, consult your local
electrical code for approved grounding methods.
For proper connection, place wire nut over wires
and twist clockwise until tight.
6. Connect supply wires using wire nut to connect the black
xture wire to the black power supply wire and the white xture
wire to the white (neutral) supply wire.
Figure C
9) Photocontrol
8) Wire nuts
7) Mounting
Screws
10)ALO/CCT
Switch
SUPPLY HOT WIRE (BLACK)
/ CABLE CALIENTE (NEGRO)
/ FIL DE PHASE (NOIR)
SUPPLY NEUTRAL WIRE (WHITE)
/ CABLE NEUTRO (BLANCO)
/ FIL DE NEUTRE (BLANC)
SUPPLY GROUND WIRE
/ CABLE DE PUESTA A TIERRA
/ FIL DE TERRE
Lumen Switch
Color Switch
7. Luminaire is preset to 2200 lumens, 4000K CCT with
Photocell ON. If desired, change settings by adjusting the switch.
See Figure D/Switch.
8. Connect photocell using orange connector. Re-install
Reector & Di󰀨user (see step 2).
9. Turn on electricity at fuse or circuit breaker box and verify
success of installation. Note: test xture at night or block
photocell.
Make sure all wiring access holes are sealed with
weatherproof silicone sealant (not included)!
Figure D
Photocontrol