Specification

TWS LED
Series Performance Package Color Temperature Voltage Control Options Finish
TWS LED 1 1017 lumens 50K 5000K
1
120 120V
2
PE Photoelectric
cell, button type
(blank) Dark bronze
TWS LED
LED Wall Luminaire
Ordering Information
EXAMPLE: TWS LED 1 50K 120 PE
NOTES
1 Corrected color temperature (CCT) shown is nominal per
ANSI C78, 377-2008.
2. 120V driver operates on 120V.
Catalog
Number
Notes
Type
One Lithonia Way • Conyers, Georgia 30012 • Phone: [phone] • www.lithonia.com
© 2013-2016 Acuity Brands Lighting, Inc. All rights reserved.
Hit the Tab key or mouse over the page to see all interactive elements.
Introduction
The popular TWS luminaire is now available with
long-lasting, energy-efficient LED technology.
Featuring a classic dayform, the TWS LED offers
a traditional appearance and is powered by
advanced LEDs.
The TWS LED luminaire is powerful yet energy
efficient, capable of replacing up to a 70W HPS
wall pack while saving up to 78% in energy costs.
With long-life LEDs, the TWS LED eliminates
frequent lamp and ballast replacements associated
with traditional technologies.
Width:
6-3/4”
(17.2 cm)
Height:
10-7/8”
(27.7 cm)
Depth:
5-5/16”
(13.5 cm)
Weight:
3.19 lbs
(1.45 kg)
Specifications
H
WD
Accessories
Ordered and shipped separately.
TWSWG Wire Guard
FEATURES & SPECIFICATIONS
INTENDED USE
The TWS LED combines traditional wall pack design with high-output LEDs to provide an
energy-efficient, low maintenance LED wall pack suitable for replacing up to 70W HPS fixtures.
The traditional shape helps maintain building aesthetics when replacing only a portion of your
building’s wall packs. TWS LED is for outdoor applications such as personnel doors, loading areas,
driveways and parking areas.
CONSTRUCTION
Back plate is die-cast aluminum. Front cover is impact-resistant polycarbonate which is fully
gasketed. All electronics are protected in the upper housing. Housing is sealed against moisture
and environmental contaminants.
FINISH
UV stabilized polycarbonate front cover has dark bronze color which provides superior resistance
to corrosion and weathering and that can withstand extreme climate changes without cracking
or peeling.
OPTICS
Protective polycarbonate lens covers the LEDs. Prismatic front cover and precision-molded
reflector for superior uniformity and fixture spacing. Light engine is available in 5000K
(69 min. CRI).
ELECTRICAL
Light engine consists of two high-powered, long-life, high-efficacy LEDs mounted on an
internal aluminum heat sink to maximize heat dissipation and promote long life (L95/100,000
hours at 40°C). Driver and integral photocell operate at 120V and are fully enclosed in the
upper housing. There are no user serviceable parts.
INSTALLATION
Back housing easily mounts to any recessed junction box. With all electronics in upper
housing the open lower section makes wiring easy. Mount on any vertical surface. Not
recommended in applications where a sprayed stream of water can come in direct contact
with polycarbonate lens.
LISTINGS
UL Certified to US and Canadian safety standards for wet-location mounting higher than 4
feet off the ground.
Rated for -40°C to 40°C ambient temperature.
WARRANTY
5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx.
Note: Actual performance may differ as a result of end-user environment and application
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specifications are subject to change without notice.