Installation Guide

Installation Instructions
TWP-LED
Part Number: RJ521354 REV B
Revision Date: 4-3-18
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: [phone] • Fax: [phone] • www.lithonia.com
© 2011 Acuity Brands Lighting, Inc. All rights reserved. 11/12
Wire Guard
WALL MOUNT:
1. Drill wall in two places for two
(2) 10-24 fasteners (not provided)
per drilling detail (Figure D).
2. Place wire guard over xture.
3. Secure in place with fasteners
from step 1.
Figure D
FIXTURE MOUNT:
1. Drill xture per drilling de-
tail (Figure E). NOTE: Remove
photoelectric cell (when provided)
before drilling for xture mounted
wire guard.
2. Place wire guard over xture.
3. Secure in place with two (2) 10-
24 fasteners, washers, and spacers
(provided) as shown (Figure F).
Troubleshooting: If this xture fails to operate properly, check to make sure: • The xture is wired correctly. • The xture is
grounded correctly. • The line voltage at the xture is correct. If all these variables have been checked and the xture still
does not operate as specied, contact your local Lithonia Lighting distributor.
Figure F
TWP Back Housing
1-1/2"
18-1/2"
Drill two places
for 10-24 fasteners
(by others)
1”from
wall
7 1/2”
Figure E